How to Hang a Snowboard on the Wall?

If you’re a snowboarder, you understand the importance of hanging your snowboard on the wall after every session. Not only does this keep your board in top condition by preventing dings and scrapes, it also lets you admire it as an art piece and a fond remembrance of your days on the slopes. Here we are sharing some tips on how to hang a snowboard on the wall so that there will be no problem at all!

Tips to Consider:

Know the Actual Measurement to Find the Area for the Board:

First, you will want to measure the area you want to hang the board. The board should fit snugly, and it will look best when centered with adequate room above and below it. You’ll need two screws and drywall anchors for each corner of the board. Make sure to use drywall anchors that are rated for at least 20 pounds in areas such as bedrooms, living rooms, and hallways where people may be. If the board is going in a place where people are less likely to bump into it, lighter anchors can be used.

Install the Drywall Anchors:

Install the drywall anchors into the walls. For each anchor, drill a hole the same size as the anchor itself into the wall. Tap each anchor into the hole using a hammer and make sure it is flush against the wall. Place the screws into the anchors, but don’t tighten them yet.

Find the Center of the Wall:

Find the center of the wall and mark where the board will hang. Place the board in the middle and mark the locations of each corner. If the board is wider than 16 inches, you can use two anchors on each side to secure it.

Hang the Board:

Now that the anchors and the board’s location have been determined, you can now hang the board. Attach the board to the screws on the anchors and gently tighten. Make sure the board is level and that it is securely attached to the wall.

Add Finishing Touches of you Want:

Finally, it’s time to add some finishing touches to your setup. You can make your display unique by adding snowboard bindings, photos, and memorabilia. Some snowboarders even opt for adding LED lights to their setup for a unique and interesting look.

Conclusion:

Taking the time to properly hang your snowboard on the wall is an important step in keeping your board in its best condition for years to come. While it may seem like a daunting task, with a little bit of planning and patience, you’ll hang your board like a pro in no time. So go out there, measure, mark, and hang. And most importantly, have fun!